MICROPROCESSORS MICROCONTROLERS LAB OPERATION OF KIT Switch on power supply. Message”ANSHUMAN” will be displayed. Press”E” then “ENTER” key. Select C=A then press www.doorway.rut address will be displayed. o Note: for changing address select C=A address. Now enter the program. At the end press “ENTER” key twice. Various features of microcontroller are given as follows: 8-bit CPU bit Program Counter 8-bit Processor Status Word (PSW) 8-bit Stack Pointer Internal RAM of bytes Special Function Registers (SFRs) of bytes 32 I/O pins arranged as four 8-bit ports (P0 - P3) Two bit timer/counters: T0 and T1 Two external and three internal vectored interrupts. MICROCONTROLLERS LAB – 18ECL47 MANUAL 15 Atria Institute of Technology, Department of ECE WORKSHEET 1. Write an ALP to generate eight Fibonacci numbers using The first term must be zero and second term must be one Add the current term and previous term, store in the next term Repeat the same processes until count become zero.
3. While coming to the lab bring the lab manual cum observation book, record etc. 4. Take only the lab manual, calculator (if needed) and a pen or pencil to the work area. 5. Before coming to the lab, prepare the prelab questions. Read through the lab experiment to familiarize yourself with the components and assembly sequence. 6. MICROPROCESSORS MICROCONTROLERS LAB OPERATION OF KIT Switch on power supply. Message”ANSHUMAN” will be displayed. Press”E” then “ENTER” key. Select C=A then press www.doorway.rut address will be displayed. o Note: for changing address select C=A address. Now enter the program. At the end press “ENTER” key twice. ECE Department MPMC Lab-PCEC MJCET Page 6 PART–B [Experiments for using any C- Cross Compiler appropriate hardware] 1. Familiarity and use of / Microcontroller trainer, and execution of programs. 2. Instruction set for simple Programs (using 4 to 5 lines of instruction code). 3.
8. Introduction to Embedded Systems laboratory. 1. Programs using Microcontroller. 9. Program 1: To write a C program to demonstrate LED using Interface the memory and I/O devices to microcontroller. Before performing the practical student shall read lab manual of related practical to be. Note: Single chip solution for interfacing is to be with C Programs for the following experiments. 8 Stepper motor interface. 9 DC motor interface for.
0コメント